| Remote Codes for Freesat Humax Receivers |
| Using the Universal Remote Control |
| 1. Select the mode (TV, PVR, DVD, AUDIO) you want to set by pressing the corresponding button on the remote control. The button will blink once. |
| 2. Keep pressing the button for 3 seconds until the button lights on. |
| 3. Enter the 4-digit code. Every time a number is entered, the button will blink. When the fourth digit is entered, the button will blink twice. |
| 4. If a valid 4-digit code is entered, the product will power off. |
| 5. Press the OK button and the mode button will blink three times. The setup is complete. |
| 6. If the product does not power off, repeat the instruction from 3 to 5. |
Note:
• When no code is entered for one minute the universal setting mode will switch to normal mode.
• Try several setting codes and select the code that has the most functions. |
| Panasonic TVs |
There seems to be a problem with Panasonic TVs, when using the remote for the Humax FOXSAT-HDR, this is due to Panasonic TVs requiring a longer signal than that given out by the receivers remote.
Try code 0650 first, input the code as instructed in the manual and then selected OK - holding down the standby button on the humax controller then turns the TV off. Try all the codes and see which gives the most control functions. |
| |
| TV, TV/DVD Combo & TV/VCR Combo Codes |
|
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
| |
| DVD & TV/DVD Combo |
 |
 |
 |
 |
 |
 |
 |
| |
| Audio & Aux Codes |
 |
 |
 |
 |
|